User`s guide

MULTI-TASKER™
400-0394-004
9
Command Format: [INyRCnUi]
y = Resolution (y = # from 0 to 3)
0 = S-Video
1 = Composite Video
2 = PC Bypass
3 = YPbPr Video
R = Recall video adjustment settings
Cn = Card ID (n = # from 1 to max slots)
Ui = Unit ID (i = # from 0 to 9)
Example:
Send the command [IN0RC4] to select the
S-Video input and recall the settings saved for
S-Video input. For example, any changes made
to the brightness, hue etc… that were saved will
be recalled.
6. [MODER]
This command sets the resolution of the video
output.
Command Format: [MODERxCnUi]
x = Resolution (x = # from 0 to 7)
0 = VGA 640x480
1 = 480p
2 = SVGA 800x600
3 = XGA 1024x768
4 = SXGA 1280x1024
5 = 567p
6 = 720p
7 = 1080i
8 = WXGA 1280x768
Cn = Card ID (n = # from 1 to max slots)
Ui = Unit ID (i = # from 0 to 9)
Example:
Send the command [MODER4C4] to set the
resolution of the card in slot 4 to 1280x1024.
7. [BRIGHTm]
This command sets the brightness level to an
absolute value.
Command Format: [BRIGHTmCnUi]
m = Level (m = # from 0 to 48, default=24)
Cn = Card ID (n = # from 1 to max slots)
Ui = Unit ID (i = # from 0 to 9)
Example:
Send the command [BRIGHT12C2] to set the
output brightness to 12 on the card in slot 2.
8. [BRIGHT]
This command is used to make the brightness
function active for use with the [ + ] and [ - ]
control commands.
Command Format: [BRIGHTCnUi]
Cn = Card ID (n = # from 1 to max slots)
Ui = Unit ID (i = # from 0 to 9)
Example:
Send the command [BRIGHTC2] to select the
brightness function on C2. Then use the [+] and
[-] commands to increase or decrease the
brightness level as desired.
9. [CONTRm]
This command sets the contrast level to an
absolute value.
Command Format: [CONTRmCnUi]
m = Level (m = # from 0 to 48,default=40)
Cn = Card ID (n = # from 1 to max slots)
Ui = Unit ID (i = # from 0 to 9)
Example:
Send the command [CONTR30C1] to set the
output contrast to 30 on the card in slot 1.