User`s guide

MULTI-TASKER
7
7
[VERC3]: equivalent to [VERC3U0]
1. [VER]
This command receives the software version and
card type for the MT110-101/103 card.
Command Format: [VERCnUi]
Cn = card ID number (n = # from 1 to 19)
Ui = Unit ID (i = # from 0 to 9) (refer to the MT100-
100 user’s guide for explanation)
Example:
If one MT110-101 card is in slot #2 of unit 3:
To send command
[VERC2U3], the Multi-Tasker™
Enclosure will return:
MT110-101 690-0152-004
2. [C]
This command receives the status of the card.
Command Format: [CnUi]
Cn = card id (n = 1 to 19)
Ui = unit id (i = from 0 to 9) (refer to the MT100-100
user’s guide for explanation)
Example:
If one MT110-101/103 card is in slot #2 of unit 3
with output 1, 2 & 3 ON:
When sending command
[C2U3], feedback will be
returned as:
Config. 8x8 offset: IN=0 OUT=0
In1 Out1 ON
In3 Out2 ON
In6 Out3 ON
In2 Out4 OFF
In4 Out5 OFF
In5 Out6 OFF
In7 Out7 OFF
In8 Out8 OFF
Description of Feedback:
Input1 is connected to Output1 and Output1 is
enabled
Input3 is connected to Output2 and Output2 is
enabled
Input6 is connected to Output3 and Output3 is
enabled
Input2 is connected to Output4 and Output4 is
disabled
Input4 is connected to Output5 and Output5 is
disabled
Input5 is connected to Output6 and Output6 is
disabled
Input7 is connected to Output7 and Output7 is
disabled
Input8 is connected to Output8 and Output8 is
disabled
Note: If there is no card in slot #2 of unit 3, sending
the
[C2U3] command will not return any feedback.
ERROR CODES
ER01: CPU Error
This error indicates that the CPU is not
working
properly.
ER02: I²C Communication Error
This means that the communication between the
MT110-101/103 card and its serial device has failed.
ER03: RS485 Communication Error
This type of error is a communication error between
the MT110-101/103 card and the controller of the
Multi-Tasker™ Enclosure.
3. [CiS]
This command is to save card status such as
ON/OFF, IN/OUT, and volume control.
4. [IO]
This command will connect input x with output y, but
the user needs to use the [ON] command to enable
this output.
Command Format: [IxOyCnUi]
Ix: select input x, x is from 1 to 8
Oy: connect to output y, y is from 1 to 8
Cn: card ID number, n is from 1 to 19
Ui: unit ID, i is from 0 to 9. (Refer to MT100-100
user’s guide to set Unit ID).
Example:
To connect input 4 to output 2 (card 2 of unit 3), use
the [I4O2C2U3] command.
[ImO*Ci]
Connect Input m to all Outputs
5. [OSImCi]
This command is set Input offset