User`s guide

MULTI-TASKER
10
10
This command sets path to adjust the
individual volume level for single card.
Command Format: [SELmCn] [–] [–] [–] [–] or
[+] [+] [+] [+]
m = Input number (m = 1 to 8)
n = Card ID number (n = slot # from 1 to 19)
+ = increases volume.(maximum of 15 levels
for audio).
– = decreases volume.(maximum of 15
levels for audio).
14. [MATmXnCi]
This command allows changes in the
configuration of the matrix. User can configure
the MT110-101 and MT110-103 Audio Matrix
Switcher as 8x8, 4x4, or 2x2.
8x8
Input Output
O1a O1a
O2a O2b
O3a O3b
O4a O4b
O5a O5b
O6a O6b
O7a O7b
O8a O8b
4x4
Input Output
O1a O1a
O1b O1b
O2a O2a
O2b O2b
O3a O3a
O3b O3b
O4a O4a
O4b O4b
2x2
Input Output
O1a O1a
O1b O1b
O1c O1c
O1d O1d
O2a O2a
O2b O2b
O2c O2c
O2d O2d
15. [HELPCi]
This command displays all available for user Multi-
Tasker interface commands.
7.3. SUMMARY OF COMMANDS
1) [VER]: Receives software version
2) [C]: Receives status of the card
3) [CiS]: Save card status
4) [IO]: Connects the input to the output
5) [OSI]: Set input offset
6) [OSO]: Set output offset
7) [ON]: Turns on one input for a single
card or a group of cards
8) [OFF]: Turns off one or more inputs
for a single card or a group of cards
9) [SW]: Switch (outputs the preloaded
buffer)
10) [SIG]: Checks if signal present
11) [CLR]: Clears members of a single
group or all groups
12) [VOL]: Sets volume
13) [SEL]: Select input to adjust volume
14) [MATmXnCi]: Change configation of
matrix.
15) [HELPCi]: Display commands.
TROUBLESHOOTING GUIDE 8
We have carefully tested and have found no
problems in the supplied MT110-101/103; however,
we would like to offer suggestions for the following
:
•
8.1 LED IS NOT LIT