User`s guide

MULTI-TASKER
9
9
output 2 and 3 remain ON.
b)
[OFF23C5]: Turns OFF output 2 and 3.
2) If card 5 of unit 3 has output 1, 2, 3, 4, 5,
6, 7 and 8 ON:
a) [OFFC5U3]: Turns OFF all outputs, which
is equivalent to
[OFF12345678C5U3].
• [OFFmGkUi]: for a group of cards
This command disables output "m" for each
card in group "k" of unit "i".
Command Format: [OFFmCnUiP]
m = card output (m = # from 1-8)
k = group number (k = # from 1-9)
i = unit number (i = # from 0-9)
Example:
1. [OFF1G5U1]: Turns OFF output 1 for
each card in group 5 of unit 1.
2. [OFFG5U1]: Turns OFF all outputs for
each card in group 5 of unit 1.
• [OFF…..P]: sets path
This command will set the path for the output,
but it is not active until the switch command is
executed ( [SW] ). Commands ending in "P"
are not executed immediately. The path for
outputs on multiple cards or the same card
can be loaded.
Command Format: [OFFmCnUiP]
m = number (m =1 to 8)
n = card ID No. (n = a slot # from 1 to 19)
P = path
Example:
If 2 cards are at slot 6 and 7 of unit 3:
To enable output 1 and 2 of card 6 and output
3 and 4 of card 7 simultaneously, use the
following commands:
[OFF12C6U3P]
[OFF34C7U3P]
[SW]
If "F" is included use the [OFFmCnUiPF]
command or the [OFFmCnUiFP]
command.
• [OFF…..F]: feedback
After processing a command, an OK or ER will
be returned as feedback if "F" is included at
the end of a command string or if the unit ID is
zero.
Example:
[OFF1C2U3F]: if path is not set
[OFF1C2U3PF]: if path is set
9. [SW] – Switch
The switch command immediately connects inputs
and outputs, which were previously set with the
path command on this card or any other cards in
the MT100-100.
Example:
[ON12C6U3P]
[ON34C7U3P]
[SW]
The system will return feedback as OK if the unit ID
is zero.
10. [SIGCi]
This command checks if signal is present.
Example:
If signal on IN1 for the MT110-101/103in slot 4
after sending command string [SIGC4] received
feedback will be 1.
11. [CLR]
This command clears the members for a single
group or for all nine groups.
Command Format: [CLRGkUi]
k = group number (k = # from 1-9)
i = unit number (i = # from 0-9)
12. [VOLnAkCi]
This command sets volume for each input in the
MT110-103 only.
n = output number (n = # from 1-8)
k = gain level (k=1 to 16)
i = unit number (i = # from 0-9)
13. [SELmCn]