Specifications

MULTITASKER
™
13
13
8.2. DISTORTED SOUND
A) Cause 1: The source level is above 1Vp-p
Solution: Make sure that the source level is
below 1V p-p. If the sound is still
distorted, see Cause 2.
B) Cause 2: The destination amplifier
provides excessive
amplification.
Solution 1: Make sure that the source signal
level is high enough so that the
destination amplifier does not
have to provide excessive
amplification and thereby distort
the signal. If there is still sound
distortion, see Solution 2.
Solution 2: Call ALTINEX at [phone]
or 1-800-ALTINEX.
8.3. SOUND LEVEL IS LOW
B) Cause 1: The volume levels are
inappropriate.
Solution 1: Turn up the source volume. If
sound level is still low, see
Solution 2.
Solution 2: Turn up the destination amplifier
volume. If the sound level is still
low, see Cause 2.
B) Cause 2: Poor signal transmission.
Solution: Check the cables for continuity
and make sure that connections
are wired properly to verify that
there is good signal transmission.
Note: Test the system by removing the MT110-
104 card from between the source and the
destination amplifier. If problem persists,
call ALTINEX at [phone] or 1-800-
ALTINEX.
ALTINEX POLICY 9
9.1. LIMITED WARRANTY / RETURN POLICY
Please see the Altinex website at www.altinex.com
for details on warranty and return policy.
9.2. CONTACT INFORMATION
ALTINEX, INC.
592 Apollo Street
Brea, CA 92821 USA
TEL: [phone]
TOLL FREE: 1-800-ALTINEX
WEB: www.altinex.com
E-MAIL: [e-mail]
FAX: [phone]