Music Mixer User Manual

MULTI-TASKER™
400-0343-003
11
11
7. […S] – SAVE
This command will save the configuration
command being sent in memory. When
sending the command [VLBA12C4S], after
reset or power up, the bass level on C4 will be
12 out of 16.
8. […F] – FEEDBACK
After processing a command, an OK or ER will
be returned as feedback if "F" is included at the
end of some command strings.
9. [ + ] and [ - ]
These commands allow a selected property to
be adjusted from keyboard commands or
programmed front panel buttons.
Command Format: [ + ], [ - ]
[+] = Increment level by one step
[-] = Decrement level by one step
Example:
Select the Output Volume command for the
card in slot #4. The current Output Volume level
is 10, but it is not the optimal value. After
sending the following commands, an optimum
volume level of 15 is obtained:
1. [SELOC4]
The current volume level is 10.
2. [ – ] [ – ] [ – ]
The level is now 7 and is too low.
3. [+][+][+][+][+][+][+][+]
The level is now 15 and no further
adjustments are required.
10. [SELIm]
This command sets the path to adjust the
INPUT volume level. The input volume range is
00 to 16 and is adjustable using the [+] and [-]
commands.
Command Format: [SELImCnUi]
m = Input (m = # from 1 to 3)
Cn = Card ID (n = slot # from 1 to max slots)
Ui = Unit ID (i = # from 0 to 9)
Example:
An MT109-102 is in slot #4. Adjust the volume
on Input 2 by sending the command [SELI2C4]
and then using the [+] and [-] commands.
11. [SELO]
This command sets the path to adjust the
OUTPUT volume level. The output volume
range is 00 to 16 and is adjustable using the [+]
and [-] commands or the Volume Ramping
commands.
Command Format: [SELOCnUi]
Cn = Card ID (n = slot # from 1 to max slots)
Ui = Unit ID (i = # from 0 to 9)
Example 1:
An MT109-102 is in slot #4. Adjust the output
volume by sending the command [SELOC4]
and then using the [+] and [-] commands.
Example 2:
The output volume may also be adjusted using
key ramping commands. See the VOLUME
RAMPING FEATURE section of this manual for
details on using this feature.
12. [SELB]
This command sets the path to adjust the bass
level. The BASS level range is 00 to 16 and is
adjustable using the [+] and [-] commands.
Command Format: [SELBCnUi]
Cn = Card ID (n = slot # from 1 to max slots)
Ui = Unit ID (i = # from 0 to 9)