User`s guide

MULTI-TASKER™
400-0202-002 8
The Group ID is a number representing a group
of cards defined with the [WR] command.
When using the Group ID, all cards in the group
will perform the given instruction.
Changing the position of a card will significantly
affect the commands recorded on software
definitions or third party control systems.
The Unit ID has a value from 0 to 9. Unit ID 0
should be used for single unit operation. If the
Unit ID is set to zero, each command may be
used without Ui. Use the command [SETU0],
as explained in the MT100-100 User’s Guide.
Example:
[VERC3]: For Unit ID Zero
[VERC3Ui]: For Unit ID other than Zero
[VERC3]: Equivalent to [VERC3U0]
1. [VER]
This command receives the software version
and card type for the MT104-106 card.
Command Format: [VERCnUi]
Cn = Card ID (n = # from 1 to max slots)
Ui = Unit ID (i = # from 0 to 9)
Example:
There is an MT104-106 card is in slot #4. Send
the command [VERC4] to the Multi-Tasker™.
The feedback will be as follows:
MT104-106 690-0158-004
MT104-106 = card type
690-0158-004 =software version
2. [C]
This command receives the status of the card.
Command Format: [CnUi]
Cn = Card ID (n = # from 1 to max slots)
Ui = Unit ID (i = from 0 to 9)
Example:
There is one MT104-106 card in slot #4 with
Input 2 ON. Sending the command [C4] to the
Multi-Tasker™ will yield the following feedback:
ON 2 C04
ON 2 = Input 2 is ON
C04 = Card is in slot 4
If there is no card in slot #4, sending the [C4]
command will not return any feedback.
3. [CnS]
This command saves the status of the card's
input enable settings. The configuration will be
restored after the system is reset or powered
off then on.
Command Format: [CnUiS]
Cn = Card ID (n = # from 1 to max slots)
Ui = Unit ID (i = # from 0 to 9)
S = save configuration
Example:
There is an MT104-106 installed in slot #4.
Input 2 of the card is turned ON. Save the
card's setting by sending the command [C4S].
The feedback will basically be the same as the
status of the card, with “Saved” as in the
following example:
ON 2 C04 Saved
4. [?Ui]
This command will return general information
about the Multi-Tasker™ and cards installed in
the unit.
Command Format: [?Ui]
Cn = Card ID (n = # from 1 to max slots)
Ui = Unit ID (i = from 0 to 9)