User`s guide

MULTI-TASKER™
400-0202-002 16
7.3 SUMMARY OF COMMANDS
Card Commands
1) [VER] Receives software version
2) [Ci] Receives status of the card
3) [CnS] Saves card configuration.
4) [?] Show system cards
5) [?C] Show card information
6) [STA] Enable/disable auto feedback
7) [ON] Turn input ON/OFF
8) [OFF] Turn output ON/OFF
9) […S] Save command configuration
10) […F] Provides feedback after send
11) […P] Set the path for [SW] command
12) [SW] Switch preloaded buffer
13) [SIG] Check for input signal
14) [CLR] Reset card to default values
15) [TEST] Test internal memory IC's
16) [FBD] Feedback delay on/off
17) [RSI] Reset Card ID’s
18) [SIDn] Set all Card ID’s
19) [SIDnCi] Set one Card’s ID
20) [SID+n] Set Card ID offset
21) [RSN] Read Card slot number
22) [HELP] Display available commands.
Group Commands
23) [WR] Groups multiple cards
24) [RMC] Remove members from group
25) [RMG] Delete group
26) [RD] Displays group members
27) [CLRG] Clears group members
28) [CLM] Delete group
7.4 MENU MODE
MENU MODE commands are RS-232 commands
that allow virtually the same functionality as
programming commands. Unlike the programming
commands in the previous sections, 7.2 and 7.3,
MENU commands prompt the user to select from a
list of available options. The system then responds
based upon selections made by the user.
MENU commands may be issued in response to
prompts from within MTSetup™ or other RS-232
communication software.
The MENU driven commands are only available
with Multi-Tasker™ Front Panel systems that have
the following firmware:
690-0122-015 = Version 015 or later.
690-0123-004 = Version 004 or later.
690-0124-018 = Version 018 or later.
NOTE: In MTSetup™, send the command [VER]
from the Terminal Window. The system will
respond with feedback similar to the following:
[690-0122-015 690-0123-004 690-0124-018]
Check the last three digits against the numbers
above to determine if MENU MODE is available.
7.4.1 MENU COMMAND DEFINITIONS
Refer to section 7.2 for details on card functions
and examples. Following is a cross-reference of
menu sections versus programming commands.
MENU COMMAND
Control
Select n/a
Save [CiS]
Clear [CLR]
Switch [ON]
Setup
Group [WR], [CLM], [RM], [RD]
Status [VER], [C]
Help [HELP]
Not Available
[?], [STA], […S], [...F], [...P],
[SIG], [SW], [TEST], [CLRG],
[FBD], [RSI], [RSNCi],
[SIDn], [SIDnCi], [SID+n]