User`s guide

MULTI-TASKER™
400-0202-002 11
PATH OPERATION
Command Format: [OFFmCnUiP]
This command will set the path for the output,
but it is not active until the switch command,
[SW], is executed. Commands ending in "P" are
not executed immediately. The path for outputs
on multiple cards or the same card may be
preloaded.
m = Input number (m = 1 to 3)
Cn = Card ID (n = # from 1 to max slots)
Ui = Unit ID (i = # from 0 to 9)
P = Path
Example:
There are two MT104-106 cards in slots 6 and
7. Disable Input 1 of card 6 and Input 3 of card
7 simultaneously using the following
commands:
[OFF1C6P]
[OFF3C7P]
[SW]
If "F" is included, use the [OFFmCnUiPF]
command or the [OFFmCnUiFP] command.
FEEDBACK OPERATION
Command Format: [OFF…..F]
After processing a command, an OK or ER will
be returned as feedback if "F" is included at the
end of a command string.
Example:
[OFF1C2F]: if path is not set
[OFF1C2PF]: if path is set
9. […S] – Save
This command will save the configuration
command being sent in memory. When
sending the command [ON1C4S], after reset or
power up, Input 1 on C4 will be enabled.
10. […F] – Feedback
After processing a command, an OK or ER will
be returned as feedback if "F" is included at the
end of a command string.
11. […P] – Path
This command will set the path for the output,
but it is not active until the switch command,
[SW], is executed. Commands ending in "P" are
not executed immediately. The path for outputs
on multiple cards or the same card can be
loaded. See examples in ON and OFF
commands.
12. [SW] – Switch
The switch command immediately connects
inputs and outputs, which were previously set
with the PATH command on this card and all
other cards in the MT100-100.
Example:
[ON1C6P]
[ON3C7P]
[SW]
13. [SIG]
The Signal Present command tests for the
presence of an input signal. The Multi-Tasker™
returns either a "1" or a "0" as feedback.
1 = Signal detected
0 = No signal detected
Command Format: [SIGCnUi]
Cn = Card ID (n = # from 1 to max slots)
Ui = Unit ID (i = 0 to 9)
Example:
There is a properly formatted input signal being
applied to the card in slot #4. Check for the
presence of an input signal by sending the
command [SIGC4].