User`s guide

MULTI-TASKER™
400-0202-002 10
GROUP OPERATION
Command Format: [ONmGkUi]
This command enables input "m" for each card
in group "k" of unit "i".
m = card input (m = # from 1-3)
Gk = group number (k = # from 1-8)
Ui = unit number (i = # from 0-9)
Example:
[ON1G1]: Turns ON Input 1 for each card in
Group 1. See the GROUP commands for a
detailed explanation.
PATH OPERATION
Command Format: [ONmCnUiP]
This command will set the path for the output,
but it is not active until the switch command,
[SW], is executed. Commands ending in "P" are
not executed immediately. The path for outputs
on multiple cards or the same card may be
preloaded.
Command Format: [ONmCnUiP]
m = Input number (m = 1 to 3)
Cn = Card ID (n = # from 1 to max slots)
Ui = Unit ID (i = 0 to 9)
P = Path
Example:
There are two MT104-106 cards in slots 6 and
7. Enable Input 1 of card 6 and Input 3 of card
7 simultaneously. Use the following
commands:
[ON1C6P]
[ON3C7P]
[SW]
If "F" is included, use the [ONmCnPF]
command or the [ONmCnFP] command.
FEEDBACK OPERATION
Command Format: [ON…..F]
After processing a command, an OK or ER will
be returned as feedback if "F" is included at the
end of a command string.
Example:
[ON1C6F]: if path is not set
[ON3C7PF]: if path is set
8. [OFF]
This command disables one or any inputs for a
single card or a group of cards.
SINGLE CARD OPERATION
Command Format: [OFFmCnUi]
m = Input (m = # from 1 to 3)
Cn = Card ID (n = # from 1 to max slots)
Ui = Unit ID (i = # from 0 to 9)
Example:
Card 4 has Input 1 ON. The following
commands may be used to turn OFF the input.
1) [OFF1C4]: Turns OFF only Input 1.
2) [OFFC4]: Turns OFF ANY inputs.
GROUP OPERATION
Command Format: [OFFmGkUi]
This command disables input "m" for each card
in a group "k" of unit "i".
m = Input (m = # from 1-3)
Gk = Group ID (k = # from 1-8)
Ui = Unit ID (i = # from 0-9)
Example:
1. [OFF1G1]: Turns OFF Input 1 for each card
in Group 1.
2. [OFFG1]: Turns OFF all inputs for each
card in Group 1.