User`s guide

MULTI-TASKER™
400-0202-002 9
Example:
A Multi-Tasker™ with Unit ID #0 has a front
panel with part number MT101-102 and
contains an MT104-106. Send the command [?]
and receive the following feedback:
[+MT101-102U0+MT104-106C04]
MT101-102U0 = Panel Number and Unit ID
MT104-106C04 = An MT104-106 is in slot 4
5. [?CnUi]
This command will return general information
about the card and its status. It is a function of
both the card and the front panel and is only
available with Multi-Tasker™ Front Panel
systems that have the following firmware:
690-0122-015 = Version 015 or later.
690-0123-004 = Version 004 or later.
690-0124-018 = Version 018 or later.
NOTE: In MTSetup™, send the command
[VER] from the Terminal Window. The system
will respond with feedback similar to the
following:
[690-0122-015 690-0123-004 690-0124-018]
Check the last three digits against the numbers
above to determine if the option is available.
Command Format: [?CnUi]
Cn = Card ID (n = # from 1 to max slots)
Ui = Unit ID (i = from 0 to 9)
The MT104-106 in slot #4 has Input 1 selected
and ON. Send the command [?C4] to receive
the feedback status.
Each status field begins with a '+' and ends with
the card slot number (ex: C04). The feedback
will be similar to the following:
[+MT104-106C04+VR690-0158-004C04+IN2C04]
MT104-106 = Card Type
VR690-0158-004 = Firmware version
IN2 = Input 2 ON and enabled
6. [STA]
This command enables/disables automatic
feedback from the front panel. The command
affects any card with auto-feedback capability,
not just the MT104-106. The default at power
on or reset is STA0, OFF.
Command Format [STA1] = ON
Command Format [STA0] = OFF
Feedback Prefix Definitions:
+VR = Firmware Version
+IN = Input Selected
Example:
Command = [ON3C4]
Feedback = [+IN3C04]
+IN = Input Select
3 = Selected Input
C04 = Card slot number
7. [ON]
This command will enable one input of a single
card, or a group of cards.
SINGLE CARD OPERATION
Command Format: [ONmCnUi]
This command enables input “m” and disables
all other inputs.
m = Input (m = # from 1 to 3)
Cn = Card ID (n = slot # from 1 to max slots)
Ui = Unit ID (i = 0 to 9)
Example:
All of the inputs on the MT104-106 card are
OFF and the card is in slot #4:
1) [ON1C4]: Turns ON only Input 1 of the
MT104-106 card.
2) [ON3C4]: Turns ON only Input 3. Input 1 is
now OFF.