User`s guide

MULTI-TASKER™
15
17. [RD]
This command displays the members in each
group.
Command Format: [RDGkUi]
Gk = Group ID (k = # from 1-8)
Ui = Unit ID (i = # from 0-9)
Example:
The cards in slots 1, 2 and 19 are part of
group 5 in Unit ID 1. Read the member data for
group 5 of Unit ID 1, by sending the command
[RDG5U1]. The system will return feedback as
follows:
G1=C1C2C19
The feedback shows G1 (Group 1) and then the
cards that make up Group 1. In this case,
Group 1 includes C1, C2 and C19.
18. [CLM]
This command removes the members in a
group and leaves the group empty.
Command Format: [CLMGkUi]
Gk = Group ID (k = # from 1-8)
Ui = Unit ID (i = # from 0-9)
Example:
Group 5 of Unit ID 1 contains the cards in slots
1, 2 and 19. Read the member data for group 5
of Unit ID 1. Send the command [RDG5U1]
and receive the following feedback:
G1=C1C2C19
Now, clear group 5 by sending the command
[CLMG5U1]. Reread the member data as above
and note the following feedback:
G1=EMPTY - PLEASE RESET THE SYSTEM
WHEN FINISHED
7.3 SUMMARY OF COMMANDS
Card Commands
1) [VER] Receives software version
2) [C] Receives status of the card
3) [CnS] Saves card settings
4) [CLR] Reset card to default values
5) [?] Show status/ general information
6) [STA] Enable/disable auto feedback
7) [TEST] Test internal memory IC's
8) […S] Save the command configuration
9) […F] Provides feedback upon sending
10) [SIG] Input Signal Detect
11) [EQ] Set/adjust equalization
12) [HP] Set/adjust Horizontal Position
13) [ + ] Increments and Decrements
[ - ] selected commands
14) [HELP] Display all available commands
Group Commands
15) [WR] Groups multiple cards
16) [CLRG] Clears group members
17) [RD] Displays group members
18) [CLM] Removes members from group.