User`s guide

MULTI-TASKER™
400-0183-002 6
DIAGRAM 2: INTERNAL VIEW
INSTALLING YOUR MT103-116 6
Step 1. Turn off the power to the Multi-Tasker™
enclosure.
Step 2. Slide the MT103-116 into an available slot
in order to connect to the bus.
Step 3. Make sure that the MT103-116 card fits
into place. Secure the card to the
Multi-Tasker™ by tightening the retainer
screws located on the top and bottom of
the card.
Step 4. Turn on the power to the Multi-Tasker™
enclosure.
Step 5. The LED on the card panel will turn red
indicating that the card is in full operation.
A green LED indicates that a signal is
present.
Step 6. Connect a CAT-5 cable from the
transmitter output to one of the inputs on
the MT103-116.
Step 7. Next, connect a VGA cable from the video
display to the output connector of the
MT103-116.
2 X CAT-5 TO VGA RECEIVER
CAT5
RJ45
IN 1
POWER/
SIGNAL PRESENT
CAT5
RJ45
IN 2
VGA
OUT 2
VGA
OUT 1