MULTI-TASKER™ MANUAL PART NUMBER: 400-0183-002 MT103-116 2-IN, 2-OUT CAT-5 TO VGA RECEIVER CARD FOR MULTI-TASKER™ USER’S GUIDE
MULTI-TASKER™ TABLE OF CONTENTS Page PRECAUTIONS / SAFETY WARNINGS .............. 2 GENERAL..........................................................2 INSTALLATION .................................................2 CLEANING.........................................................2 FCC / CE NOTICE..............................................2 ABOUT YOUR MT103-116 ................................... 3 TECHNICAL SPECIFICATIONS .......................... 3 PRODUCT DESCRIPTION ..................................
MULTI-TASKER™ PRECAUTIONS / SAFETY WARNINGS 1.4 FCC / CE NOTICE 1 • Please read this manual carefully before using your MT103-116. Keep this manual handy for future reference. These safety instructions are to ensure the long life of your MT103-116 and to prevent fire and shock hazard. Please read them carefully and heed all warnings. 1.1 GENERAL • • Qualified ALTINEX service personnel, or authorized representatives must perform all service. 1.
MULTI-TASKER™ ABOUT YOUR MT103-116 2 TECHNICAL SPECIFICATIONS MT103-116 2-In 2-Out CAT-5 to VGA Receiver Card FEATURES/DESCRIPTION MT103-116 GENERAL Two Inputs Input Connectors RJ-45 Two Outputs Output Connectors 15-pin HD Female Cable Distance Limitations 640x480: 500ft/152m 1280x1024: 350ft/107m 800x600: 450ft/137m 1600x1200: 250ft/76m 1024x768: 400ft/122m The MT103-116 is a high-resolution 2-in 2-out CAT-5 to VGA receiver.
MULTI-TASKER™ PRODUCT DESCRIPTION 4 MT103-116 TOP RETAINER SCREW VGA OUTPUT 1 POWER/SIGNAL PRESENT LED EQUALIZATION ADJUSTMENT KNOB CAT-5 INPUT 1 CAT-5 INPUT 2 EQUALIZATION ADJUSTMENT KNOB POWER/SIGNAL PRESENT LED VGA OUTPUT 2 BOTTOM RETAINER SCREW 400-0183-002 4
MULTI-TASKER™ APPLICATION DIAGRAM 5 DIAGRAM 1: TYPICAL SETUP MT103-116 DA1920SX DA1920SX 400-0183-002 5
MULTI-TASKER™ DIAGRAM 2: INTERNAL VIEW 2 X CAT-5 TO VGA RECEIVER POWER/ SIGNAL PRESENT CAT5 RJ45 IN 1 VGA OUT 1 CAT5 RJ45 IN 2 VGA OUT 2 INSTALLING YOUR MT103-116 6 Step 5. The LED on the card panel will turn red indicating that the card is in full operation. A green LED indicates that a signal is present. Step 1. Turn off the power to the Multi-Tasker™ enclosure. Step 2. Slide the MT103-116 into an available slot in order to connect to the bus. Step 6.
MULTI-TASKER™ OPERATION 7.2 NO DISPLAY 7 Cause 1: The source has a problem. Solution: Check the source and make sure that there is a signal present and all source connections are correct. If the source is working and there is still no display, see Cause 2. Cause 2: Cable connections are incorrect. Solution: We have carefully tested and have found no problems in the supplied MT103-116; however, we would like to offer suggestions for the following: Make sure the cables are connected properly.
