User`s guide

MULTITASKER
400-0089-005
16
7.3. SUMMARY OF COMMANDS
Basic Commands
1) [VER] Display firmware version
2) [C] Display card status
3) [CnS] Save card settings
4) [TEST] Test internal memory ICs
5) [HELP] Display available commands
Feedback Commands
6) [FBD] Feedback delay on/off
7) [?] Display system cards
8) [?C] Display card information
9) [STA1] Auto-feedback on
10) [STA0] Auto-feedback off
11) [...F] Display OK after command
Card Control Commands
12) [...S] Save command being sent
13) [SIG] Test for an input signal
14) [ON] * Enable one or more outputs
15) [OFF] * Disable one or more outputs
16) [...P] Sets the path, [SW] preload
17) [SW] Switch preloaded outputs
ID Commands
18) [RSI] Reset Card IDs to defaults
19) [SIDn] Set all Card IDs
20) [SIDnCi] Set one Card ID
21) [SID+] Set all Card IDs to an offset
22) [RSN] Display card slot number
Group Commands
23) [WR] Add card(s) to a group
24) [RMC] Remove card(s) from group
25) [RMG] Delete group
26) [RD] Display group members
7.4 MENU MODE
Menu Mode commands allow virtually the same
functionality as programming commands. Unlike
the programming commands in the previous
sections, menu commands prompt the user to
select from a list of available options. The system
then responds based upon selections made by the
user.
7.4.1 MENU COMMAND DEFINITIONS
Refer to section 7.2 for details on card functions
and examples. Following is a cross-reference of
menu mode sections versus programming
commands.
MENU COMMAND
Control
Select n/a
Save [CnS]
Clear [CLR]
On/Off [ON], [OFF]
Setup
Group [WR], [RMC]
Status
[VER], [C]
Help
[HELP]
* MT103-103 ONLY