User`s guide

MULTITASKER
400-0089-005
12
14. [ON]
MT103-103 ONLY
This command enables one or more outputs of a
single card or group of cards. If there is an
expansion card attached to the MT103-103, the
expansion card must be controlled separately.
SINGLE CARD
Command Format: [ONmCn]
This command enables output “m” without
affecting any other outputs. If “m” is blank, all
outputs are turned on.
m = Output number (m = # from 1 to 6)
n = Card ID (n = # from 1 to max slots)
Example:
1) [ON12C4]: Turn on Outputs 1 and 2 of C4.
2) [ON3C4]: Turn on Output 3 of C4
3) [ONC4]: Turn on all the outputs on C4.
GROUP OF CARDS
Command Format: [ONmGk]
This command enables output “m” of group “k”
without affecting any other outputs. If “m” is
blank, all outputs are turned on.
m = Output number (m = # from 1 to 6)
k = Group ID (k = # from 1 to 8)
Example:
1. [ON1G5]: Turns on Output 1 for each card
in group 5.
2. [ONG5]: Turns on all outputs for each
card in group 5.
USING THE PATH COMMAND
[ON…..P]: sets path
This command will set the path for the output,
but it is not active until the switch command is
executed, [SW]. Commands ending in "P" are
not executed immediately. The path for outputs
on multiple cards or the same card can be
preloaded.
Command Format: [ONmCnP]
m = Output number (m =# from 1 to 6)
n = Card ID (n = # from 1 to max slots)
P = Path
Example:
There is an MT103-103 in slot 2 (C2) and
another MT103-103 in slot 4 (C4). In order to
enable Output 1 of C2 and Output 3 of C4
simultaneously, use the following commands:
[ON1C2P]
[ON3C4P]
[SW]
15. [OFF]
MT103-103 ONLY
This command disables one or more outputs of
a single card or group of cards. If there is an
expansion card attached to the MT103-103, the
expansion card must be controlled separately.
SINGLE CARD
Command Format: [OFFmCn]
This command disables output “m” without
affecting any other outputs. If “m” is blank, all
outputs are turned off.
m = Output number (m = # from 1 to 6)
n = Card ID (n = # from 1 to max slots)
Example:
1) [OFF12C4]: Turn off Outputs 1 and 2 of C4.
2) [OFF3C4]: Turn off Output 3 of C4
3) [OFFC4]: Turn off all outputs of the C4.