User`s guide

MT115
MT115MT115
MT115-
--
-110 Video+Audio Dual TP Transmitter
110 Video+Audio Dual TP Transmitter110 Video+Audio Dual TP Transmitter
110 Video+Audio Dual TP Transmitter User’s Guide
User’s GuideUser’s Guide
User’s Guide
400-0433-006 8
Basic Commands
The basic commands are used to provide general information about the
card. These commands are most useful during the initial stages of setting
up and operating the card.
1. [VER]
This command displays the software version and card type for the
MT115-110 card.
Command Format: [VERCn]
Cn = Card ID (n = slot # from 1 to max slots)
Example:
An MT115-110 card is in slot 4. Send the command [VERC4], and the
system will return feedback similar to the following:
[MT115-110 690-0231-003 C04]
MT115-110 = Model number
690-0231-003 = Firmware version
C04 = Card ID/slot number
2. [C]
This command displays the status of the card.
Command Format: [Cn]
Cn = Card ID (n = # from 1 to max slots)
Example:
There is an MT115-110 card in slot 4. Sending the command [C4] will
yield feedback similar to the following:
INPUT#1 NO SIGNAL
VIDEO GAIN 4
EQUALIZATION 32
INPUT#2 NO SIGNAL
VIDEO GAIN 4
EQUALIZATION 32
In this case, both card inputs are set for a video gain of 4 and an
equalization of 32.
If there is no card in slot 4, sending the [C4] command will not return
any feedback.
3. [CnS]
This command saves the card settings and displays the status. After the
system is reset or powered off and on, the settings are restored.
Command Format: [CnS]
Cn = card number
S = save configuration
Example:
Save the status by sending [C4S]. The feedback returned will be
similar to the following:
INPUT#1 NO SIGNAL
VIDEO GAIN 4
EQUALIZATION 32
INPUT#2 NO SIGNAL
VIDEO GAIN 4
EQUALIZATION 32
[SAVED]
4. [...S]
This command saves the configuration command being sent in
memory. When sending the command [EQ1=16C4S], after reset or
power-up, the equalization for Input 1 will be set to 16. No other
settings will be saved.
5. [CLR]
This command clears the card settings and returns it to the factory
default values:
Video Gain = 4 (Input 1 and Input 2)
Video Eq = 32 (Input 1 and Input 2)
Command Format: [CLRCn]
Cn = Card ID (n = slot # from 1 to max slots)
Example:
In order to clear the card in slot 4, send the command [CLRC4]. The
card will respond with the following feedback when complete:
FACTORY RESET COMPLETED
6. [TEST]
This command performs a series of tests on the internal memory and
displays a pass message if successful. Otherwise, failures are indicated.
Command Format: [TESTCn]
Cn = Card ID (n = slot # from 1 to max slots)
Upon completion, the system will display the results. This feedback
will be similar to the following:
MEMORY IC TEST RESULTS:
MEMORY IC PASS