User`s guide

MULTI-TASKER™
13
Command Format: [WRCn…GkUi]
Cn = Card ID (n = slot # from 1 to max slots)
Gk = Group number (k = # from 1-8)
Ui = Unit ID (i = # from 0-9)
Example:
To group cards 1, 2, and 3 as group 5 of Unit ID
1, send the command [WRC1C2C3G5U1]. After
executing this command, cards 1, 2 and 3 will be
grouped together as group 5 of Unit ID 1. The
system will return the following feedback:
G1=C1C2C3
14. [CLRG]
This command clears the members for a single
group or for all groups. The clear command
restores the cards to default settings.
Command Format: [CLRGkUi]
Gk = Group number (k = # from 1-8)
Ui = Unit ID (i = # from 0-9)
Example:
1) To clear group 1, send the [CLRG1U1]
command. This command clears the
members for the specified group only.
2) To clear all groups of Unit ID 1, send the
[CLRG✻U1] command.
NOTE: Since this command is sending the
[CLR] command to its group members,
each card will display its own reset
message.
15. [RD]
This command displays the members in each
group.
Command Format: [RDGkUi]
Gk = Group number (k = # from 1-8)
Ui = Unit ID (i = # from 0-9)
Example:
The cards in slots 1, 2 and 19 are part of group 5
in Unit ID 1. Read the member data for group 5
of Unit ID 1, by sending the command [RDG5U1].
The system will return feedback as follows:
G1=C1C2C19
The feedback shows G1 (Group 1) and then the
cards that make up Group 1. In this case, Group
1 includes C1, C2 and C19.
16. [CLM]
This command removes the members in a group
and leaves the group empty.
Command Format: [CLMGkUi]
Gk = Group number (k = # from 1-8)
Ui = Unit ID (i = # from 0-9)
Example:
Group 5 of Unit ID 1 contains the cards in slots 1,
2 and 19. Read the member data for group 5 of
Unit ID 1. Send the command [RDG5U1] and
receive the following feedback:
G1=C1C2C19
Now, clear group 5 by sending the command
[CLMG5U1]. Reread the member data as above
and note the following feedback:
G1=EMPTY - PLEASE RESET THE SYSTEM
WHEN FINISHED