User`s guide

SWITCHER
2
PRECAUTIONS / SAFETY WARNINGS 1
Please read this manual carefully before using your
SW1956CT Switcher. Keep this manual handy for
future reference. These safety instructions are to
ensure the long life of your SW1956CT and to
prevent fire and shock hazard. Please read them
carefully and heed all warnings.
1.1 GENERAL
• Qualified ALTINEX service personnel, or their
authorized representatives must perform all
service.
1.3 INSTALLATION
• For best results, place the SW1956CT on a flat,
level surface. Keep in a dry area away from dust
and moisture.
• To prevent fire or shock, do not expose this unit
to rain or moisture. Do not place the SW1956CT
in direct sunlight, near heaters or heat radiating
appliances, or near any liquid. Exposure to direct
sunlight, smoke, or steam can harm internal
components.
• Handle the SW1956CT carefully. Dropping or
jarring can damage internal components.
• Do not place heavy objects on top of the
SW1956CT. If the unit is to be mounted to a
table or wall, use only Altinex made mounting
accessories.
• To turn off the main power, be sure to remove
the cord from the power outlet. The power outlet
socket should be installed as close to the
equipment as possible, and should be easily
accessible.
• Do not pull the power cord or any cable that is
attached to the SW1956CT Switcher.
• If the SW1956CT is not used for an extended
time, disconnect power cord from the outlet.
1.4 CLEANING
• Unplug the SW1956CT power cord before
cleaning. Clean surfaces with a dry cloth. Never
use strong detergents or solvents, such as
alcohol or thinner. Do not use a wet cloth or
water to clean the unit.
1.5 FCC / CE NOTICE
• This device complies with Part 15 of FCC Rules.
Operation is subject to the following two
conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference, including interference
that may cause undesired operation.
• This equipment has been tested and found to
comply with the limits for a Class A digital
device, pursuant to Part 15 of FCC Rules. These
limits are designed to provide reasonable
protection against harmful interference when
equipment is operated in a commercial
environment. This equipment generates and
uses radio frequency energy. If not installed and
used in accordance with the instruction manual,
it may cause harmful interference to radio
communications. Operation of this equipment in
a residential area is likely to cause harmful
interference in which case the user will be
required to correct the interference at his own
expense.
• Any changes or modifications to the unit not
expressly approved by Altinex, Inc. could void
the user’s authority to operate the equipment.