DISTRIBUTION AMPLIFIERS ISC2000-W/ISC2000-I MANUAL PART NUMBER: 400-0087-004 INTERA™ COMPUTER VIDEO + AUDIO INPUT MODULE USER’S GUIDE
DISTRIBUTION AMPLIFIERS TABLE OF CONTENTS INTRODUCTION This manual covers: Page PRECAUTIONS / SAFETY WARNINGS ..............2 ISC2000-W – VGA & Audio (white) Line Driver GENERAL..........................................................2 ISC2000-I – VGA & Audio (ivory) Line Driver INSTALLATION..................................................2 CLEANING.........................................................2 FCC / CE NOTICE .............................................
DISTRIBUTION AMPLIFIERS PRECAUTIONS / SAFETY WARNINGS 1.4 FCC / CE NOTICE 1 • Please read this manual carefully before using your ISC2000-W/ISC2000-I. Keep this manual handy for future reference. These safety instructions are to ensure the long life of your ISC2000-W/ISC2000-I and to prevent fire and shock hazard. Please read them carefully and heed all warnings. 1.1 GENERAL • • Qualified Altinex service personnel, or their authorized representatives must perform all service. 1.
DISTRIBUTION AMPLIFIERS ABOUT YOUR DISTRIBUTION AMPLIFIER 2 MECHANICAL The ICS2000 is a 1-in, 1-out VGA and Audio Line Driver designed for installation into a wall. The unit provides a method of transmitting signals to a remote display and audio receiver or amplifier.
DISTRIBUTION AMPLIFIERS PRODUCT DESCRIPTION 400-0087-004 4 4
DISTRIBUTION AMPLIFIERS 4.1 VIDEO INPUT The computer input is a 15-pin HD connector on the front of the ICS2000-W/ISC2000-I. It is connected to the video output of a desktop computer or similar device. PIN No. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 4.3 AUDIO INPUT & OUTPUT The ISC2000-W/ISC2000-I accepts computer audio input and offers balanced stereo output through a terminal block connector on the back. There is a 3.5mm jack for computer audio input.
DISTRIBUTION AMPLIFIERS APPLICATION DIAGRAM 5 TYPICAL SETUP BREAKOUT VIDEO CABLE CONNECTION SCREW HOLE SCREW MOUNTING HOLE BREAKOUT CABLE CONNECTOR VIDEO OUTPUT 400-0087-004 6
DISTRIBUTION AMPLIFIERS INSTALLING YOUR LINE DRIVER Step 4. Attach the breakout cable to the video output connector. Make sure the breakout cable's connector mounting hole aligns with the ISC2000 screw hole and secure it with the screw provided. See Application Diagram 2 for details. 6 PREPARATION Step 1. There are a few common items to check before testing the setup connections: a. Make sure the monitor and sound system work with the source computer before using the ISC2000. b.
DISTRIBUTION AMPLIFIERS TROUBLESHOOTING GUIDE 8.3 NO SOUND/BAD SOUND QUALITY 8 NOTE: For very small audio signals, the amplifier for the speakers must necessarily amplify both the signal and any noise in the system. For very large audio output signals, distortion and clipping may occur. The source and the audio amplifier function best when the audio levels are set to midrange values. This is normal for an audio system regardless of whether an ISC2000 is used.
DISTRIBUTION AMPLIFIERS Cause 4: Destination amplifier is bad. ALTINEX POLICY Solution 1: Make sure that the destination amplifier is powered. If there is still no sound, see Solution 2 9.1 LIMITED WARRANTY/RETURN POLICY Please see the Altinex website at www.altinex.com for details on warranty and return policy. Solution 2: Set the volume of the destination amplifier to a reasonable level. If there is still no sound, call ALTINEX at (714) 990-2300. 9.
