User`s guide

INTERFACES

eliminated. The output is provided through a 15-pin

HD connector.

4.4. HORIZONTAL POSITION ADJUSTMENT

KNOB

Although most monitors and projectors are fully

capable of adjusting the horizontal position of the

image, in some instances it is helpful to adjust the

horizontal position at the interface. This control is

also helpful when using multiple computers.

In some cases, adjusting the horizontal position at

the interface may simplify the projector set up.

4.5. EXTERNAL POWER ADAPTER

The DA1910SX is powered using a 9V 500mA

unregulated linear AC power supply adapter. The

power regulation is provided inside the unit. The

adapter uses a 2.5mm connector with a center

conductor (+) and a shell (-). A selection of several

power adapters is available for different countries

from 110 VAC to 240 VAC. A DA1291SX Power

Adapter security kit that connects to the side of the

unit is available to insure the permanent attachment

of the power adapter connector.

DA1910SX DESCRIPTION (CON’T)

4.6. MOUNTING CAPABILITY

The DA1910SX is designed for easy mounting to a

table, wall, or inside a rack using the DA1295SX

mounting brackets. Two mounting holes are

provided on each side of the unit for the mounting

brackets.

4.7. DIP – SWITCHES SETTING

DIP SWITCH OFF ON

Sync on G X

ID Bit X

Serration X

Terminate X

H Posit ON X

H&V Out X

Table 6. Dip-switches default setting

4.8. SYNC ON GREEN OUTPUT SWITCH

Often systems that use large matrix switchers are

designed to switch signals in the RGsB format. This

is done to reduce the cost of the switcher. In

systems of this type, the ability of the DA1910SX to

output sync on green can be a very helpful feature.