User`s guide

INTERFACES
2
2
PRECAUTIONS / SAFETY WARNINGS 1
Please read this manual carefully before using your
DA1910SX Interface. Keep this manual handy for
future reference. These safety instructions are to
ensure the long life of your DA1910SX and to
prevent fire and shock hazard. Please read them
carefully and heed all warnings.
1.1. GENERAL
• Do not open the unit or power supply case, there
are high-voltage components inside.
• There are no user serviceable parts inside. Only
qualified ALTINEX service personnel must
perform all service on the DA1910SX.
1.2. SAFETY GUIDELINES FOR THE RACK-
MOUNTING OF THE DA1910SX
• Maximum operating ambient temperature is 35
(degrees C).
• Never restrict the airflow through the devices’ fan
or vents.
• When installing equipment into a rack, distribute
the units evenly. Otherwise, hazardous
conditions may be created by an uneven weight
distribution.
• Connect the unit to a properly rated supply
circuit.
• Reliable Earthing (Grounding) of Rack-Mounted
Equipment should be maintained.
1.3. INSTALLATION
• For best results, place the DA1910SX Interface
on a flat, leveled surface in a dry area away from
dust and moisture.
• To prevent fire or shock, do not expose this unit
to rain or moisture.
• To turn off the main power, be sure to remove
the adapter from the wall. The power outlet
socket should be installed as close to the
equipment as possible, and should be easily
accessible.
• Do not place the DA1910SX Interface in direct
sunlight, near heaters or heat radiating
appliances, or near any liquid.
• Exposure to direct sunlight, smoke, or steam can
harm internal components.
• Handle the DA1910SX Interface carefully.
Dropping or jarring can damage internal
components.
• Do not place heavy objects on top of the
DA1910SX.
• Do not pull the adapter or any cable that is
attached to the DA1910SX Interface.
• If the DA1910SX is to be mounted to a table or
wall, use only Altinex made mounting
accessories, such as brackets (DA1295SX) and
cables for optimum setup.
• If the DA1910SX Interface is not used for an
extended period, disconnect the adapter from the
wall to avoid fire, shock, and loss of power.
1.4. CLEANING
• Unplug the DA1910SX adapter before cleaning.
• Clean surfaces with a dry cloth. Never use
strong detergents or solvents such as alcohol or
thinner. Do not use a wet cloth or water to clean
the unit.
1.5. FCC / CE NOTICE
• This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired operation.
• This equipment has been tested and found to
comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable
protection against harmful interference when the
equipment is operated in a commercial
environment. This equipment generates, uses,
and can radiate radio frequency energy and, if
not installed and used in accordance with the
instruction manual, may cause harmful
interference to radio communications. Operation
of this equipment in a residential area is likely to
cause harmful interference in which case the
user will be required to correct the interference at
his own expense.