INTERFACES MANUAL PART NUMBER: 400-0008-004 PRODUCT REVISION: 8 DA1910SX COMPACT ANALOG INTERFACE USER’S GUIDE
INTERFACES TABLE OF CONTENTS INTRODUCTION Page Thank you for purchasing the DA1910SX Compact Analog Interface. We are sure you will find it a reliable and useful product. PRECAUTIONS / SAFETY WARNINGS............... 2 GENERAL ......................................................... 2 INSTALLATION ................................................. 2 CLEANING ........................................................ 2 FCC / CE NOTICE.............................................
INTERFACES PRECAUTIONS / SAFETY WARNINGS • Exposure to direct sunlight, smoke, or steam can harm internal components. • Handle the DA1910SX Interface carefully. Dropping or jarring can damage internal components. • Do not place heavy objects on top of the DA1910SX. • Do not pull the adapter or any cable that is attached to the DA1910SX Interface. • If the DA1910SX is to be mounted to a table or wall, use only Altinex made mounting accessories, such as brackets (DA1295SX) and cables for optimum setup.
INTERFACES • Any changes or modifications to the unit not expressly approved by Altinex, Inc. could void the user’s authority to operate the equipment. ABOUT YOUR INTERFACE Output Buffered Local Monitor Output Compatibility 2 There are a great variety of computers and computer video cards on the market today. There are also numerous data monitors and large screen data projectors.
INTERFACES Vertical 25-180 Hz Minimum Video Bandwidth 350 MHz Typical Video Bandwidth 425 MHz 20% Horizontal Position Range 39dB @100 MHz Cross-talk Power External Power Adapter (AC) X Power Adapter 9V 500 mA (included) 1.0 watts max. Power Consumption Table 3.
INTERFACES eliminated. The output is provided through a 15-pin HD connector. 4.6. MOUNTING CAPABILITY The DA1910SX is designed for easy mounting to a table, wall, or inside a rack using the DA1295SX mounting brackets. Two mounting holes are provided on each side of the unit for the mounting brackets. 4.4.
INTERFACES Note: the DA1910SX will not separate the Sync signal from the Green signal if the input is RGsB. It will simply amplify video and pass it through. It will however, combine Sync with Green Video when the switch is in the ON position, regardless of whether the input sync is Composite or H&V. rule, this switch should be ON. The switch should be OFF only if a monitor breakout cable is used with a local monitor. 4.12.
INTERFACES the HORIZONTAL POSITION knob of the DA1910SX. 4.14. BANDWIDTH The typical bandwidth of the DA1910SX is 420 MHz. The minimum bandwidth is 350 MHz. This exceptionally high bandwidth allows the passing of the third harmonics of the video signal, thus maintaining the highest quality of the input signal. OPERATION The settings of the DA1910SX Interface can be adjusted using the Dip-switches as described in section 4. There are no other adjustments necessary to operate the unit.
INTERFACES Model No. Description RACK MOUNT ACCESSORIES Power adapter security kit. DA1291SX Rack/Wall mount brackets for DA1295SX DA1900 series. COMBO-PACK VGA+MAC INPUT & OUTPUT cables SUPER-PACK VGA+MAC+SUN/SGI INPUT & OUTPUT cables Table 9. Optional accessories 5 The standard available cables are 3 feet in length, please call 1-714-990-2300 for a wider selection of cables (6 ft, 12 ft).
INTERFACES TROUBLESHOOTING GUIDE 1. Please make sure that the amplitude level of the input signal is as follows: a) RED, GREEN, and BLUE are less than 1.2 Volts b) HSYNC & VSYNC are less than 5.0 Volts 2. Please use only Altinex supplied Power Supply (AC Adapter) for proper operation. 3. If problems show up on the display after continuous usage at higher voltage, higher temperature, higher humidity, or at other extreme environmental conditions, please correct those extreme conditions. 4. 5. 6.
