User`s guide

DISTRIBUTION AMPLIFIERS
6
INSTALLING YOUR DISTRIBUTION
AMPLIFIER 6
Step 1. Connect the 9V 500mA AC adapter’s
output plug to the DA1907SX’s power
input connector - 2.5 mm DC Jack. Verify
that a red LED is displayed in the top right
corner of the unit on the front panel.
Step 2. Remove the protective port covers.
Connect the video output from the
computer to the computer input connector
on the DA1907SX using the provided
CB3703MR-3 feet input VGA cable. If a
longer cable is required, please make sure
that the cable has video signals through
coaxial cables and this cable is not
excessively long.
Step 3. Verify that the red LED on the face of the
unit has now turned green, indicating an
active source. If the LED is not green, the
computer may not be sending video
signals (check your Computer’s User’s
Manual). If you are using a laptop
computer, you will have to toggle (a
command that instructs the laptop to
output to the internal display and the
external video port simultaneously) the
display or connect simultaneous displays.
Step 4. Connect your display device (monitor or
projector) to the Main output connector
using the proper cable with 15-pin HD
Male connector. Connect a monitor to
Local Monitor output port, if needed
through a 15-pin HD Male to Female
cable.
Step 5. Verify that the picture quality on all
displays is good. If you are not receiving a
signal, make sure that the display is
compatible with the resolution of the
computer graphics card. Note: High levels
of static discharge under some conditions
may shutdown the unit. To reset the unit
simply, disconnect the input cable and
reconnect it back.
CONGRATULATIONS! YOU ARE DONE.
OPERATION 7
There are no adjustments necessary to operate the
DA1907SX, the unit will operate successfully as
long as cables are attached properly and other
technical specifications are followed.
ACCESSORIES 8
Model No. Description
TERMINATION PLUGS/GENDER
CHANGERS
MS8000TP
15-pin HD VGA termination plug
MS8144MG
15-pin HD (M) to 15-pin HD (M) gender
changer
MS8145MG
15-pin HD (F) to 15-pin HD (F) gender
changer
RACK MOUNTING BRACKETS
DA1295SX
Rack/Wall mount mini-brackets for
DA1900 series distribution amplifiers (2 -
"L" shaped brackets)
INPUT
CABLES
STANDARD HD-15 PIN VGA MALE TO
MALE
CB3703MR 3 ft [provided with DA1907SX]
CB3706MR
6 ft
CB3715MR
15 ft
CB3725MR
25 ft
CB3750MR
50 ft (Super High Resolution Coaxes)
CB3775MR
75 ft (Super High Resolution Coaxes)
CB37100MR
100 ft (Super High Resolution Coaxes)
CB37150MR
150 ft (Super High Resolution Coaxes)
OUTPUT
CABLES
STANDARD HD-15 PIN VGA MALE TO
FEMALE
CB3903HR
3 ft
CB3906HR
6 ft
CB3915HR
15 ft
CB3925HR
25 ft
CB3950HR
50 ft (Super High Resolution Coaxes)
CB3975HR
75 ft (Super High Resolution Coaxes)
CB39100HR
100 ft (Super High Resolution Coaxes)
CB39150HR
150 ft (Super High Resolution Coaxes)
If you experience any problems, please call
1-800-258-4623 or 1-714-990-2300 for
international calls.