Installation manual

Software Installation
AltiWare OE System Administration Manual 47
Software Installation
New Installation
Before New Installation
Note: TritonT1 Rev A1/A2 or VoIP Rev A1/A2 boards are not supported
in OE 4.5. These boards must be replaced with Rev A3 or later
boards.
Before you begin, have the following at hand:
•SystemKey
• The 20-digit software license key (located on the End User License
Agreement)
• The system home area code
• The extension length
Note: The extension length, which is from 3–7 digits, is the number
of digits for all extension numbers. All extensions in the
AltiServ configuration must be the same length.
You cannot change the extension length once the first
extension is configured, which is something you do later
running the AltiWare Setup. To change the extension after
extensions are configured requires reconfiguring the entire
system or deleting all the extensions already configured.
• Internet Explorer 5.0 or higher (for online registration)
To Begin New Installation
To install AltiWare OE:
1. Make sure you have prepared for installation as described beginning
on page 40.
2. Install the System Key on the parallel or USB port.
Caution: Do not connect the system key to any AltiGen board as
damage may occur to the board or the system key.
3. Login to Windows NT or Windows 2000 as a domain or local user
account that has local administrator privileges.