Installation manual

System Requirements
AltiWare OE System Installation & Administration Manual 37
System InstallationSystem
Requirements
System
Requirements
Operating Environment
Before you set up and use the system, consider the environment in which
the system will reside:
• Choose a work surface large enough to accommodate the entire
system.
• Use a flat, stable work surface with enough space around it for proper
air circulation. For proper heat dissipation, a fan is recommended in
front of the AltiGen telephony boards to ensure sufficient airflow. Be
sure the fan filter is clean and does not block the airflow.
The following table contains the operating specifications for the AltiGen
telephony board.
Heat Factor
Internal system temperature must not exceed the specified operating
temperature. If more than two AltiGen telephony boards are installed in the
system, then additional cooling fans are suggested. These fans need to
effectively reduce heat and increase airflow to the AltiGen telephony
boards to ensure system reliability.
Installing a Cooling Fan
If more than two AltiGen telephony boards are installed in the AltiServ
system, then an additional cooling fan will be required. This fan needs to
effectively reduce heat and increase airflow to the AltiGen telephony
boards to ensure system dependability and reliability. To install a cooling
fan into the AltiServ system, read the instructions included with the fan
unit.
Description Specification
Operating Temperature 0° to + 50° C
Storage Temperature -20° to +70° C
Relative Humidity 10% to 80% non-condensing