Installation manual

Configuration
310 AltiWare OE System Installation & Administration Manual
• Static IP address assigned to each extension configured for an IP
connection (recommended, but not required)
Client
• An AltiGen-certified IP phone device (see “Clients” on page 311 for
details)
• High-speed data connection to the AltiServ system (minimum 64kbps)
Configuration
You must configure AltiAdmin and, in some cases, your client hardware or
software for using IP extensions.
AltiAdmin
1. Ensure that the VoIP gateway is configured properly and works.
For details on configuring the Triton VoIP board and the IP trunks,
refer to “Configuring the Triton VoIP Board” on page 147 and “Setting
General Trunk Attributes” on page 173.
2. Ensure that you can make calls over IP by creating an entry (at least an
entry with the IP address of the AltiServ system) in the IP dialing table
and then dialing <IP Trunk access code> + <IP dialing table entry
code> + <extension number>. Make sure you can have a two-way
conversation on this VoIP call.
For details on using the IP dialing table, see “Defining the IP Dialing
Table” on page 130. Also see “Setting VoIP Codecs” on page 197.
3. For each extension for which you are enabling IP extensions, check
Enable IP Extension on the General tab of the Extension
Configuration window.