Installation manual

xxiv AltiWare OE System Installation & Administration Manual
installation of extension cards does not result in non-conformance to
the Safety Requirements above.
6. When installing a system using AltiGen’s cards, note that the
continued compliance to the LVD and EMC EU Directives at the
system level is the responsibility of the system supplier.
7. Prepare above cards ensuring all jumpers are set according to the
manufacturer’s instructions.
8. Attach suitable grounded ESD wrist strap between wrist and earth.
9. Follow the manufacturer’s instruction and install above cards into PC.
10. Note: If more than three cards are using the MVIP, ensure that the
QuantumorTritonboardsetasboardzeroisinstalledatoneendofthe
MVIP cable and the board at the far end of the MVIP cable has its
switch set to terminated (switch closed).
11. Replace PC outer case.
12. Connect a fixed earth from the PC to a suitable premises fixed earthing
point. Note that the earth cable must be at least the same gauge as the
live wire of the main cord and fixed to the earth terminal and the rear
of the PC. (6 AWG recommended, 8 AWG minimum.)
13. Connect cable supplied with AltiServ to the “D-type sub-miniature”
(25 pin) connector on the AltiServ card and the connector to the
Modular RJ-11 Patch Panel.
14. Connect the building telecommunication wiring to the RJ-11 sockets.
15. Building telecommunication wiring should be installed according to
the National Wiring Regulations for Telecommunications.
Warranty
What The Warranty Covers
AltiGen Communications warrants its hardware products to be free from
defects in material and workmanship during the warranty period. If a
product proves to be defective in material or workmanship during the
warranty period, AltiGen Communications will, at its sole option, repair,
refund or replace the product with a like product.