Installation manual

Setting General Trunk Attributes
178 AltiWare OE System Installation & Administration Manual
Trunk Seizure
Confirmation
Select from:
• Enable Dial Tone Detection (Outgoing)—
detection of outgoing dial tone.
• Enable Polarity Detection (Incoming)—
detection of incoming polarity. Polarity
detection is used when the CO or the connected
PBX provides polarity reversal on the tip and
ring.
Disconnect
Supervision
Select from:
• Tone—busy tone (reorder tone, fast busy tone,
error tone, etc.) or dial tone (continuous tone,
etc.). This should be used in conjunction with
drop in loop current. For COs who cannot
guarantee loop break, this may be the only
option.
• Polarity Reversal—a reversed battery signal.
You can set the LoopBreakSignalto either
200 or 600 ms.
Receive Gain Slide setting adjusts the incoming volume from
-6dBto6dBforeveryTritonAnalogTrunkchannel.
The default setting is 0dB, and it is highly recommended
not to change this setting.
Caution: Setting the volume too high will cause
distortion in voice quality and/or missed
DTMF digits.
Transmit Gain Slide setting adjusts the outgoing volume from
-6dBto6dBforeveryTritonAnalogTrunkchannel.
The default setting is 0dB, and it is highly recommended
not to change this setting.
Caution: Setting the volume too high will cause
distortion in voice quality and/or missed
DTMF digits.
Parameter Description