Installation manual

Board Configuration
AltiWare OE System Installation & Administration Manual 143
Board Configuration
Use the Board Configuration window for the Quantum board to view the
following attributes:
Parameter Description
Board Info Board Logical ID: assigned by AltiServ.
Board Name: the type of board installed in the
system and board ID.
Note: For Quantum boards in a Windows 2000
system:
• the physical board ID 0 is not supported
• the valid physical board IDs are 1–15
Channel Mapping
List
Logical Channel, Physical Span,andPhysical
Channel for the entire board.
To reset the channel, select the channel to reset and
click the Reset Channel button, then click OK.
Note: Depending on whether the channel is a line or
a trunk line, double clicking a channel in this
window invokes either a Line Properties
window (see “Quantum Line Properties” on
page 200, or a Trunk Line Properties window
(see “Quantum Trunk Properties” on page
176).
Span Info Not available for Quantum boards.
Board Configuration Opens a diagnostic dialog box.
Figure 3. Quantum Board Debug
You can send a debug string to the board, or you can
do a DSP Dump, Memory Dump, or FMIC Dump.