Installation manual

System Configuration
AltiWare OE System Installation & Administration Manual 131
System
Configuration
System
Configuration
Setting the Location ID Digit Length
Set the length in the Location ID Digit Length drop-down list, noting the
discussion about the length in the previous section.
Defining Remote Locations
To add a location, click the Add button to open an entry dialog box:
Define the attributes for the entry:
Parameter Description
Location ID A unique dialing number to connect to the remote
location. The length of the number is of course the
Location ID Digit Length described in “About the
Location ID Digit Length” on page 129.
Location Name A descriptive name of up to 15 characters to identify
the location. This name may be used by Caller ID.
Server IP Address The remote server’s address in one of the following
formats:
• RFC assigned IP address (e.g. 100.100.100.100).
IP addresses with prefixes of 10.0.0.0/8,
172.16.0.0/12 or 192.168.0.0/16 can only be used
within private networks (Intranets).
• Fully qualified DNS name (e.g.,
newyork.altigen.com), of up to 64 characters.
This IP address format is recommended over DNS
names, since with the IP address, the application does
not need to resolve the name.