User guide

Chapter 4: System Configuration
72 MAXCS ACC 6.5 Administration Manual
#27 – Station Login
#32 – Enter Account Code
#33 – Do Not Disturb
#36 – Call Forwarding
#37 – Remote Call Forwarding
Other Features:
#12 – Language Setting
#38 – Outside Call Blocking
#39 – Operator Offline
#44 – Overhead Paging
#45 – Overhead Paging by Trunk
#46 – Group Paging
#53 – Outgoing Workgroup
#54 – Login Workgroup
#56 – Logout Workgroup
#59 – Workgroup Call Monitor
#66 – Trace Collection
#73 – Silent System Call Park
#90 – READY to Receive Workgroup Call
#91 – NOT READY to Receive Workgroup Call
Session Types:
Specify whether or not to allow an AltiGen SDK session for the extension.
Note: If the extension is an IP extension, #26 / #27 is still available when the phone
is in the onhook position, even if it is disabled in the extension’s feature profile.
To add a Feature Profile
By default, a System feature profile is assigned as 0. To add a new Feature Profile, click
the Add button. The Add Feature Profile dialog box appears, where you can type in a
Name for the feature profile.
Figure 18. Add Feature Profile dialog box
Note: When adding a feature profile, the system will automatically assign the lowest
available number.
Select the check boxes for the MAXCS feature codes that you want to be associated with
this feature profile, then click Apply.
After the System Administrator creates a Feature Profile, the Feature Profile can be
assigned to a specific extension from the General page of Extension Configuration.
(See “Setting Personal Information” on page 197 for more information on assigning a
feature profile to an extension.)