User guide

Chapter 26: Redundancy Configuration
MAXCS ACC 6.5 Administration Manual 373
Figure 5. Monitoring the status and configuring the addresses of VM server and Enterprise
server
When the Address of the Softswitch Server Changes
Configure the new address on the VM server and the Enterprise server.
VM Server
If the address of the Softswitch is changed, you need to configure the new address on
the VM server so that the VM server can connect to the correct softswitch. Do this using
the Voice Message Server Utility. Run ...\AltiServ \exe\VMMonitor.exe to launch the
utility, shown in the following figure.