Owner manual

MaxCS 7.5 Administration Manual 399
Figure 233. Signaling Layer
6. In the E1 Channel Configuration dialog box, configure the following fields:
• Set Calling Party Category to – the Calling Party Category indicates the type of calling party, (for
example, operator, pay phone, priority, ordinary subscriber). Select 1, 2 or 3 (for ordinary subscribers,
refer to Table on page 400). If the subscribed line is intended for other purposes, contact your CO for
the proper value.
• Add extra digits before caller ID – consult your CO to find out if any extra digits are needed.
• Incoming sequences – select check box and configure the sequence according to Table on page
400.
• In-call signaling – configure the in-call signaling value according to Table on page 400.
The circled fields in Figure 233 represent values that depend on your country and its corresponding trunk
property.
Note: Consult your CO to find out if caller ID digits are provided in the lines.