Owner manual

MaxCS 7.5 Administration Manual 137

C HAPTER

Trunk Configuration

Trunk attributes and parameters are set using the Trunk Configuration window. The attributes and options

available depend on the type of board and trunk. This chapter discusses general configuration options appli

cable to all trunks, followed by specific configuration options for the following trunk types:

• SIP tie trunk, page 142

• SIP trunk for ITSP, page 142

• Triton T1/PRI trunk, page 147

• Triton analog trunk, page 149

This chapter also discusses incoming call routing (page 156) and outgoing call blocking (page 157), both

configurable on tabs in the Trunk Configuration window.

Trunks Out of Service

If none of the trunks are available when an outside call is placed, the caller will hear the system prompt: “All

outside lines are busy. Please try again later.”

Channel Identification

To find out channel information, right-click a trunk in the Trunk View window (see Figure 83) and select

Channel Physical Location. The Channel Information box opens, displaying logical board ID, board name,

channel group type, and channel ID:

Figure 83. Channel Information box