Owner manual

Configuring the Triton T1/E1 Board
MaxCS 7.5 Administration Manual 119
Figure 67. E1 PRI Protocol Configuration dialog box (top half)
Figure 68. E1 CAS Protocol Configuration dialog box (top half)
Selecting Span Types
• E1 CAS – Select this option to associate all channels on the span to E1 channel associated signaling.
• Regular ISDN PRI – Select this option to indicate 30B+D ISDN PRI span and to designate the 16th
channel as the D channel.
• Enable Tie Trunk – Check this box to enable a tie trunk. Tie trunks must terminate to a system also
configured as a tie trunk.
Note: This option not available when T1 CAS is selected.
Setting the ISDN PRI Switch Mode
If you select a Span Type of Regular ISDN PRI in the T1 PRI Configuration Window, use the following
guidelines to set the ISDN PRI Switch mode.