User manual
Table Of Contents
- iFusion SmartStation User Manual
- Contents
- Introduction
- Setup
- Making and answering calls
- Adjusting the volume
- Playing music
- Synchronizing data
- Using iFusion with FaceTime
- Determining your Firmware version
- Troubleshooting
- 1. On your iPhone, choose Settings > General > Bluetooth.
- 2. In the Bluetooth device list, tap the blue right arrow beside iFusion xxxxxxx.
- 3. Tap Forget this Device.
- 4. Turn off your iPhone (hold the power button down, then move the slider to the right).
- 5. Unplug the iFusion. Wait 10 seconds, and then plug it back in.
- 7. Turn on your iPhone.
- 8. Pair your iPhone with the iFusion again.
10 iFusion SmartStation User Manual
Note: While you are playing music or other audio, pressing the Speaker button has no
effect (although the button itself will glow).
Synchronizing data
You can synchronize data such as e-mail, calendar, contacts, music, photo, and other
media files between your iPhone and the computer, through iFusion.
1 Install the iPhone application software and driver on the computer.
2 Use a mini-USB to USB standard cable (not provided) to connect the computer and
the iFusion
.
3 Plug your iPhone to the docking cradle. The computer acknowledges the iPhone.
4 To synchronize data between your iPhone and the computer, follow the instructions
provided with the iPhone application software.
Notes:
• It will take slightly longer to charge the iPhone when the iFusion is connected to a
comp
ute
r, because the charging power will come from the computer.
• The USB cable is only f
or data synchronization; to power your iFusion, you must
connect and plug in the power cord.