Specifications

IP 710 Manual 29
9. On the second line of the LCD screen, the following messages are
displayed in succession:
—CHECK MEMORY (RAM checking state)
—CHECK FW (Firmware checking state)
—INIT NETWORK
—LOADING FW...
—LOADING NOW.
—Boot Done
—INITIALIZING
10. You may verify the new version of firmware: Press the Menu button,
scroll to SYSTEM and press Enter, scroll to Version Info and
press Enter.
Resolving Errors Upon Rebooting
If an error occurs during rebooting, the LED light of the following soft keys
will remain on to indicate an error status. These errors represent hardware
failures within the IP 710 phone.
• Intercom LED light on = memory check failed
• Headset LED light on = network failed
• Conference LED light on = DHCP failed
• Hold LED light on = attached IP address failed
If the phone successfully passes through these stages, it has started up
properly. Otherwise, refer to “Troubleshooting” on page 43.
Configuring NAT
NAT (Network Address Translation) is the translation of an IP address
used within one network to a different IP address known within another
network. One network is designated as the inside network, the other is the
outside. The IP 710 can be enabled to support H.323 behind NAT. The IP
710 will be able to work behind a regular NAT router without any special
implementation for H.323.
For more detailed information regarding NAT configuration guidelines and
implementation, refer to the AltiWare OE/ACC or ACM System
Administration Manual.