Specifications

IP 710 Manual 26
Registration
Under normal circumstances, the IP 710 phone registers itself
automatically. However, if registration failed for some reason (for
example, the server was not available), registration can be started again
from the IP 710 phone’s menu:
1. Press the Menu button.
2. Scroll to REGISTER.
3. Press the Enter button.
Enabling/Disabling DHCP
Dynamic Host Configuration Protocol (DHCP) automatically assigns IP
addresses to devices when they are connected to the network. The IP 710
enables DHCP by default. If you do not use DHCP in your network, you
can disable DHCP before manually assigning an IP address to the IP 710.
Note: Procedures involving configuring IP settings cannot be completed
when DHCP is enabled on the IP phone.
To enable/disable DHCP, follow these steps:
1. Press the Menu button.
2. Press the  button to select NETWORK, then press the Enter button.
3. Scroll to ENABLE DHCP, then press Enter.
4. Press / to toggle to YES or NO and press Enter.
5. Restart the phone to obtain IP confirmation information from the
DHCP server
Enable NAT Network >
Enable NAT
Sets whether NAT is enabled or
disabled.
NAT Address Network >
NAT Address
Sets the NAT server’s public IP
address.