Specifications

IP 710 Manual 21
Rebooting the IP 710 Phone
To reboot the IP 710, press * * 3, then press the Enter button.
Note: When the IP 710 is rebooted, the AltiWare IP address setting
reverts to the original configuration.
To Use IP 710 in Power over Ethernet Mode
1. Unplug the power cord.
2. Remove the screw on the PoE Module cover, and remove the cover.
3. Plug in the PoE Module as illustrated below. The side with four pins
in the middle faces the top.
4. Put the PoE module cover back, and tighten the screw.
5. Move the DC/PoE switch to the PoE position.
6. Connect the phone to an AltiGen-certified PoE-enabled switch.
Note the centered
pins are at the top