Specifications

IP 710 Manual 17
c. The phone will attempt to register, as shown in the LCD screen:
If the phone successfully passes through these stages, the phone
shows the date, time, and extension in the LCD screen and is now in
normal operating mode.
Otherwise, refer to “Troubleshooting” on page 43.
Remote Installation
To install the IP 710 phone at a remote location, using a broadband
connection with or without a router:
1. Check the firewall settings at the corporate network to open TCP/
UDP ports required by the IP 710. (For more information on firewall
settings, refer to “Firewall Considerations” on page 42.)
2. Check the AltiWare server’s IP extension settings (make sure the IP
extension is enabled, enough physical extension licenses are
available, etc.)
3. If DHCP is not used, configure the phone’s local IP address and
Gateway IP address. (Depending on the Internet Service Provider’s
recommendations, you may or may not want to use DHCP.)
a. Press the Menu button, scroll to NETWORK, and press the Enter
button.
b. Scroll to LOCAL ADDRESS, then press Enter.
c. Enter the IP address, using the * key to input periods, then press
Enter.
4. If a NAT server is used, return to the NETWORK menu and set the
ENABLE NAT setting to YES.
5. If configuring with an H.323 NAT router, the NAT router can forward
IP traffic to a specified private IP address based on the destination
REGISTERING...
01/12 04:16PM x300