Specifications

Alti-IP 600 Administration Manual 13
If the phone successfully passes through these stages, the phone shows
the time and extension in the LCD screen and is now in normal
operating mode.
Otherwise, refer to “Troubleshooting” on page 35.
Plug and Play Setup
The steps for plug and play setup will vary depending on whether or not the
Alti-IP 600 Phone has been started. When the Alti-IP 600 is started for the
first time, it can support plug and play to enable the phone to automatically
register itself to AltiServ. If the Alti-IP 600 has already been started, follow
the instructions “Plug and Play Setup After IP Phone is Started” on page 14.
Important Notes:
• To use the Plug and Play feature, the user’s IP Phone must be on the
local LAN with AltiServ
• There can only be one (1) AltiServ on the LAN.
• Gatekeeper auto discovery uses broadcast UDP packets which work in
the LAN or VPN environment, but not through the public IP network.
Plug and Play Setup Before IP Phone is Started
To set up your IP Phone to properly execute the Plug and Play feature,
perform the following steps BEFORE YOU START THE PHONE:
1. Ensure the AltiGen GateKeeper is running and configured to point to
the AltiWare system.
2. Ensure DHCP server is up and running.
3. Ensure that there are enough IP addresses.
4. Ensure that there is an available virtual extension with the IP extension
feature enabled and dynamic IP address is selected.
5. Power up the IP Phone.
6. Enter the extension number and password.