Specifications

Alti-IP 600 Administration Manual 12
To connect the Alti-IP 600:
a. Connect an Ethernet cable from the IP-PBX to the network port on
the phone.
b. Connect the handset to the receiver jack.
c. Connect an Ethernet cable from another network device, such as a
desktop computer, to the access PC port on the phone.
d. Connect the power plug to the AC Adapter port.
4. Configuring Startup Network Settings
If you are using DHCP
, you do not need to configure anything.
Proceed to Step 5.
If you are not using DHCP
, you must configure these network settings
on the Alti-IP 600 after installing the phone on the network:
• Local IP address
• IP subnet mask
• Default gateway IP address
5. Configuring the AltiWare IP Settings
If you are using Gatekeeper Auto Discovery
, you do not need to
configure anything. Proceed to Step 6.
If you are not using Gatekeeper Auto Discovery
, you must manually
configure the AltiWare IP address setting into the Alti-IP 600. Refer to
“Configuring IP Settings” on page 24.
6. Activate the IP Extension
Once the device is initialized, the user must follow these steps to
activate the IP Extension.
Note: The user must be running AltiGen’s Gatekeeper service for full
functionality.
a. With the handset onhook, press #27, then the ENTER button.
b. Enter your extension number and password when prompted.
c. The phone will attempt to register as shown in the LCD screen.