Specifications

Alti-IP 600 Administration Manual 10
Important:When updating the Alti-IP 600 phone’s firmware, it is
recommended that administrators perform any updates after
normal business hours or when the IP phone is not in use. If the
Alti-IP 600 phone is in use during an update, the call will be
disconnected.
General Allows you to specify the IP address of the AltiServ system
the Alti-IP 600 phone is connected to. The version of
software associated with AltiServ is automatically displayed
in the Version field.
To allow the extension user to have password-protected
configuration functionality from the phone itself, check the
Enable Config Password checkbox and assign a numerical
password. When the extension user attempts to configure
features, the user will need to enter the assigned password to
proceed.
H.323 Allows you to set the Jitter Buffer in milliseconds, the delay
used to buffer voice packets received from the IP network.
The Jitter Buffer should be adjusted according to the WAN
bandwidth allocated to data traffic.
To allow NAT support for the IP extension, check the
Enable NAT button and enter the public IP address of the
NAT router.
TFTP Allows you to assign the TFTP Server to which the IP phone
can connect to for updating firmware when necessary. Enter
the IP address of the TFTP Server in the Server field. Check
the Reset IP Phone and Boot Download checkbox options
to reset or reboot the phone, respectively.
Debug When enabled, allows the Alti-IP 600 phone to connect to
Telnet for debugging.
Parameter Description