Specifications

Setting up Extensions
14-14 AltiContact Manager Administration Manual
Caution: If the Receiver Gain or the Transmission Attenuation
setting is too high, the result will be distortion in voice
quality.
Feature Profile
Use the Feature Profile drop-down list to select an extension feature
profile that includes enabling or disabling of extension features. The
feature profile must first be configured by the administrator in the Feature
Profiles page of System Configuration (“Feature Profiles” on page 5-39).
Flash Duration
Specifies the Flash Duration time in milliseconds:
• 50-600
• 100-700
• 150-800
• 200-900
• 300-1000
Ringing Frequency
Specifies the number of rings: 28 or 20
Line Disconnect
Signal
The loop break desired for answering supervision,
either 200 or 600 ms.
Ringing Frequency
Select the frequency in Hz that is necessary for the
equipment attached to this line.
Caller ID
Transmission
Methods
Specifies how Caller ID will be detected:
• CID between 1st and 2nd ring - Caller ID is
received between first and second ring.
• DT-AS+CID prior to ringing - Dual Tone
Alerting Signal Caller ID is received prior to
ringing.
• RP-AS+CID prior to ringing - Ring Pulse
Alerting Signal Caller ID is received prior to
ringing.
Receiver Gain/
Transmission
Attenuation
Incoming and outgoing volume for every extension.
Unlike the Quantum board, these slide settings have
positive and negative values. Both defaults are 0
decibels. The range is -3 to +3 decibels.
Parameter Description