Specifications

Triton T1/PRI Trunk Properties
7-26 AltiContact Manager Administration Manual
Note: In order for back-to-back T1/E1 and tie trunk T1/E1 configurations
to perform properly, it is recommended that you use the system’s
default incoming call sequences:
Incoming
sequence
Select up to five incoming symbols to collect from the
Caller ID or DID digits:
• None
•#
•*
• # or *
• Caller ID
• DID/DNIS
Selecting ‘None’ in any field of the sequence will terminate
the sequence and automatically disable subsequent entries
in the sequence.
The default sequence is:
“# or *” (and then) “Caller ID” (and then) “# or *” (and
then) “DID/DNIS”
Or Sets up an additional, alternative sequence. You can select
another set of up to five incoming symbols to collect.
Not checking any box is equivalent to checking ‘None’ in
the first field.
The default sequence is:
“DID/DNIS”
Use Trunk as
Mobile Trunk
When enabled, this trunk will be used as a mobile trunk for
mobile extension use. Refer to “Alti-Mobile Extensions”
on page 22-1 for more information.
Apply to… If appropriate, you can use this button, as described in
“Configuring One or Multiple Trunks” on page 7-3, to
apply the Caller ID Collection to multiple T1 trunks.
Parameter Description