Specifications
Table Of Contents
- Preface: About This Manual
- Overview
- Key AltiContact Manager Characteristics
- Call Center/IP PBX Features
- Automatic Call Distribution Features
- IVR Features
- AltiGen Voice Mail Features
- Internet Integration Features
- System Administration Features
- T1/PRI/E1 Features
- Voice over IP Features
- Voice over IP Session Support AltiContact Manager Features
- AltiWare Tools
- Optional Add-On Software
- Optional Add-On Products
- Optional Kits
- Key AltiContact Manager Characteristics
- System Requirements
- Hardware Requirements
- System Key Requirement
- Selecting the AltiContact Manager Platform
- Minimum System Requirements
- Proper Grounding and Loop Current
- Uninterruptible Power Supply (UPS)
- Operating Environment
- AltiGen Telephony Boards
- Functional Specifications
- AltiGen Board Installation
- AltiGen Board Options
- System Limitations
- Power Requirements
- Heat Factor
- Installing a Cooling Fan
- Proper Board Handling Procedures
- Electrostatic Discharge (ESD) Warning
- Operating Environment
- Packaging for Shipment and Storage
- AltiContact Manager Conference Resource Limits
- Software Installation
- Software License Activation and Registration
- New Installation
- Upgrading AltiWare OE
- License Activation and Registration Process
- Online License Registration Procedures
- Manual Online License Registration Procedure
- Offline Registration Procedures
- Windows Emergency Repair Disk
- Installing ACM Administrator on Remote Systems
- Running ACM Administrator
- Shutting Down AltiContact Manager when Changing or Adding Hardware
- Transferring the AltiContact Manager to Another Server Chassis
- AltiContact Manager Uninstall
- Software Installation Troubleshooting
- Getting Around ACM Administrator
- System Configuration
- Setting General Parameters
- Setting a System Number Plan
- Setting Business Hours
- Routing Calls on Holidays
- Configuring System Speed Dialing
- Defining System Call Restrictions
- Creating Account Codes
- Setting up Call Reports
- Using a Tenant Table
- Country Relevant
- CT-Bus Clock Configuration
- Audio Peripheral Configuration
- Board Configuration
- Trunk Configuration
- Voice Mail Configuration
- VoIP Configuration
- Defining an IP Dialing Table
- Setting VoIP Codecs
- Network Configuration Guidelines for VoIP
- Network Configuration Guidelines for the Alti-IP 600
- Configuration Guidelines for NAT
- Firewall Considerations
- Setting up H.323 Traffic Forwarding for H.323 NAT
- Setting Up an AltiContact Manager-to- AltiContact Manager IP Network
- Out Call Routing Configuration
- IVR Configuration
- CallCenter Configuration
- Agent Configuration
- Huntgroup Configuration
- Workgroup Configuration
- Setting Up IP Extensions
- Alti-IP 600 Phone Configuration
- Application Extension Configuration
- System Data Management
- System Report Management
- Data and Internet Integration
- AltiWeb
- Using TAPI
- Tools
- Basic Call Router & Call Router Advanced
- Call Accounting Report Formats
- E1 R2 CAS Installation
- Product Repair Services & Technical Support
- Glossary
- Index
- Readers Comment Form
Data and Internet Integration
AltiContact Manager Administration Manual 21-5
21. Data and Internet
Integration
•ObtaintheSubnet Mask. You will need to enter this address later
in the TCP/IP configuration setup for both the server and client
stations.
Step 2: Setup the Router
Install the router on the LAN. The router is the gateway to another LAN or
to the Internet.
1. Specify a router that is on the same LAN as the AltiWare server, such
as ISDN or T1.
2. Assign an IP address (one of the block of IP addresses obtained from
the ISP to the router). This becomes the gateway router address.
Step 3: Configure TCP/IP Properties
Configure the TCP/IP protocol parameters.
1. Open the Control Panel and select the Network icon. The Network
Setting window is displayed.
Figure 1. Network Setting window