User guide

Chapter 4: System Configuration
AltiWare ACC 5.1 Administration Manual 67
Exporting Through a Local Port
You can send the CDR to a COMM Port to export to, for example, a call accounting data
processing system.
To do this, select the Enable Data Output box in the Accounting Data Processing
field group. Then select an Available Port and the Baud Rate.
Country-Relevant Settings
The Country Relevant tab in the System Configuration window contains group boxes
for setting toll call prefixes and emergency numbers.
The Country field displays the country selected on the System Configuration, General
tab.
Figure 13. System Configuration, Country Relevant tab
Setting Toll Call Prefixes
AltiWare uses Toll Call Prefixes to determine the type of outside call and imposes
restrictions when necessary. For example, if the international toll call prefix is 011 and
a user attempts to make an international call from an extension without international call
privileges, the call will be terminated as soon as the user dials 011 after the trunk or
route access number. The caller hears an error tone.
The toll prefixes set here should match the dialing plan prefixes for the country set in
the General tab (see “Setting General Parameters” on page 47). You can set the
following toll call prefixes.