User guide

Chapter 5: Board Configuration
AltiWare ACC 5.1 Administration Manual 79
Configuring the Triton Analog Trunk LS/GS and LS
Boards
The Triton Analog Trunk board is a long form factor PCI telephony card that supports 8
or 12 trunks, and is available in two models; loop start/ground start (LS/GS) and loop
start (LS). Both models have the same features regarding LS. The LS/GS board is
required when ground start trunks may be required.
Double-click the board in the Boards window to open the Board Configuration
window, similar to Figure 2 on page 76. See attribute descriptions below Figure 2. Note
the following additional information:
• Double-clicking a channel in the Channel Mapping List opens a channel
configuration dialog box. See “Triton Analog Station Line Properties” on page 134.
• Clicking the Board Configuration button opens the following dialog box that
displays the board’s serial number, DSP clock, physical and logical IDs. For
information on adding and removing mobile trunks, see “Mobile Extension
Configuration” on page 239.
Figure 4. Board Configuration dialog box
Configuring the Triton VoIP Board
It is strongly recommended that system administrators review the “Network
Configuration Guidelines for VoIP” on page 263 before setting up VoIP features.
Overview
VoIP for AltiWare runs on both SIP and H.323 protocols that allow voice calls to be made
through an IP network. It includes an integrated VoIP gateway to convert voice calls into
IP packets and transmit them through the IP network.
AltiWare VoIP uses DSP engines residing on the Triton VoIP board to perform the voice
coding/decoding functions needed for SIP and H.323 devices.
The Triton VoIP board can be configured as a 12-port G.711/G.723.1/G.729AB or 30-
port G.711 board.
For limitations on configuring Triton VoIP boards and ports see the AltiGen Telephony
Hardware Manual.