User guide

System Requirements and Installation
MAXCS ACM 6.5 Administration Manual 31
Setup cannot detect your system key.
You must plug your system key into
either a parallel or USB port for
upgrading to MAXCS.
Make sure your system key is fully
inserted into your parallel or USB port
prior to installing MAXCS. If error
persists, reboot the system, then run
setup again.
Setup has not detected your system
key. If you proceed the installation
WITHOUT the system key, only 8
physical ports will be available for use
after the MAXCS installation.
Make sure your system key is fully
inserted into your parallel or USB port
prior to installing MAXCS.
Setup cannot append the AltiServ
path because your existing system
environment is too long. You must
manually append the AltiServ path to
your system environment path after
finishing the MAXCS installation but
before restarting your system.
Manually append c:\AltiServ\exe (if
MAXCS is installed on c: drive) to your
system environment path (through
Control Panel > System >
Advanced tab > Environment
Variables > System Variables) after
finishing the MAXCS installation but
before restarting your system.
Unable to add AltiServ path to the
system.
Manually append c:\AltiServ\exe (if
MAXCS is installed on c: drive) to your
system environment path (through
Control Panel > System >
Advanced tab > Environment
Variables > System Variables) after
finishing the MAXCS installation but
before restarting your system
Failed to upgrade AltiServ databases. The previous database may be
corrupted. Restore the last, known
working database and try again. If
error persists, contact your Authorized
AltiGen Dealer.
Error Message Solution